|
The
following are (4) great tips when using the BrewTender
commercially or at home. Some we came up with from our own
design/test-marketing/experience… Some we’ve received from various
Pubs & Sports Bars that are successfully and proudly using the
BrewTender tm.
Bar-Tenders…
Tip
(1)
To minimize foaming during filling with carbonated beverages: Before
filling the BrewTender from the tap or container, first
fill the ice-chamber with ice and insert into the BrewTender…
Tilt the BrewTender slightly while gently filling the
beverage chamber against the beverage chamber wall.
Even
greater reduction of foaming can be achieved simply by rinsing the BrewTender
with cold water prior to filling, whereby damping and cooling down
the beverage chamber – this really helps!
Bar-Tenders
& Servers…
Tip
(2)
Carrying the BrewTender:
It is best to
place one hand just under the raised boss area on the base (where the
tap connects with the base)… This will stabilize the BrewTender
when filled and make carrying it with balance and confidence – easy!
Tip
(3)
Lazy-Suzan: Before
bringing the filled BrewTender to the table - It may work
best for the server to pre-place the Lazy-Suzan on the table… this way
the server needs only to bring the filled BrewTender to
the table and place it onto the Lazy-Suzan - for everyone to
enjoy!
Tip
(4)
Lighting the BrewTender:
When using the lighting
device, it is easiest to switch on the light before the BrewTender
is brought to the table. After the Bartender has filled the BrewTender,
and hands the BrewTender to the server, either the server
or the bartender clicks the bottom switch on. The server then takes the
lit-up BrewTender over to the table – showcasing
your premium Beer!
Trouble Shooting Tips...
If
the Tap is dripping/leaking:
If your BrewTender’s tap/faucet is dripping or
leaking, generally this
means the internal plunger is not snug enough to make proper contact
within the tap-mechanism. This usually can be easily remedied…
Simply twist the horizontal threaded
screw-piece located just beneath the tap-handle clockwise (to
tighten). The screw-piece has
external finger-grip protrusions for easy manipulation.
Note:
When tightening, a little is a lot - Do not
over-tighten! Over-tightening may cause permanent damage.
Extra
Light-bulbs
Each BrewTender comes with 2 additional (spare) lantern
lighting system light-bulbs. You
will find these spare bulbs incased within a transparent housing
attached to the lantern lighting systems bottom base-plate next to the
battery housing.
The
BrewTendertm Is
a registered trademark
|